Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Kent, WA crawl space stops feeding moisture into the floor joists above it.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Open foundation vents pull in humid outside air, which is often the real driver of Kent, WA crawl space condensation — we seal them as part of encapsulation.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Kent Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Kent Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Kent Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Kent Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Kent, WA climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Standing water doesn't disqualify a space from encapsulation; it's just the first step in the process.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
We encapsulate crawl spaces throughout Kent and the surrounding Kent, WA service area, including the zip codes listed below.
Zip codes we serve in Kent, WA: 98031 98030 98032 98042 98035 98064 98089
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
